Cookies are not enabled in your browser and may affect website resources. We recommend that you turn it on.
The N2000 Universal Process Controller is a real breakthrough in versatility for holding in one single instrument all the major features required in the vast majority of industrial processes.
With a sophisticated and consistent software and its advanced truly universal circuitry, the N2000 accepts configuration of both input signal and control output through the front keyboard without any internal hardware change.
Power supply for remote loop powered transmitters is standard and is a must for high-end applications.
From the very simple applications as a temperature controller to the most complex systems of distributed control with PLC’s or SCADA networks, the N2000 is the right answer to your needs for industrial or laboratory automation.
The N2000S is specific for applications in controlling servo motorized valves, servo actuators and dampers by means of two time proportional relays.
- Accepts thermocouples type J, K, T, N, R, S; Pt100 RTD, linear 4-20 mA, 0-50 mV, 0-5 Vdc
- Dual SPST 3A/250 Vac relays and dual SPDT 5A/250 Vac relays can be individually programmed for control or alarm
- Double LED display: red for PV and green for SV
- Isolated 4-20mA output with 1500-level resolution, maximum 550 ohm load for control or PV/SV retransmission. It can also be configured for digital input or output (10 Vdc/20 mA)
- Sampling rate: 4 measurements per second
- One digital input for dry contact with 5 programmable functions
- Remote setpoint input for 4-20 mAdc signal (N2000)
- 24 Vdc/30 mA supply output for remote transmitter excitation
- RS485 comm with Modbus RTU protocol (optional)
- Auto tuning PID control
- Auto/Manual mode, bumpless transfer
- Programmable Soft start up to 9999 seconds
- Ramp and Soak: 7 programs of up to 7 segments each. Can be linked to create longer programs of up to 49 segments
- Measured value resolution: 12,000 levels
- Control output update: 250 ms
- Up to four configurable relays, two timer alarms
- Alarm functions: LO, HI, differential, differential LO, differential HI, sensor break and event
- Alarm initial blocking function
- Power: 85 to 250 Vac, 50/60 Hz; optional 24 Vdc/ac
- Maximum consumption: 4 VA
- Front panel: IP65, Polycarbonate UL94 V-2
- Back panel: IP20, ABS+PC UL94 V-0
- Circuitry can be removed from the front panel
- Enclosure: IP20
- Operating environment: 0 to 55ºC, 20 to 90%RH
- Dim ensions: 48 x 96 x 92 mm
- Panel cutout: 45.5 x 93 mm
- Weight: 240 g (265 g with options)
N2000 process controller has a universal input that accepts most sensors and signals used in the industry, as well as RS485 serial communication with Modbus RTU protocol.
A Brazilian ceramic tile company intended to deactivate two smaller kilns and reduce its gas consumption, whose bill was close to U$ 100,000 per month. The N2000s, a PID controller specifically designed for actuation of servomotor valves, has emerged as the ideal solution to the problem.